Antec Dark Fleet DF-35 Uživatelský manuál stáhnout pdf (Strana 18)

Insert your drive as shown.

2. With one hand supporting the drive, fasten the drive with the screws provided.

3. Find a small 4-pin white connector on the power supply and connect it to the male 4-pin connector

on the floppy drive.

2.7 USINGFLEET‐SWAP™

The DF-35 includes one set of Fleet-Swap

3.5” drive bays. Each set contain two connectors, for a total of

two hot-swappable SATA drive bays, pre-installed on the bottom of the internal 3.5” drive cage.

PREPARING YOUR FLEET-SWAP™ SATA BAYS FOR USE

1. Remove the left side panel of the case. Open the Fleet-Release

Access Door by pressing the left

side to release it, then swing it open. Locate the Fleet-Swap bays inside the drive cage.

Fleet-Swap™ default locations

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 32 33

Žádné komentáře

Antec Dark Fleet DF-35 Uživatelský manuál Strana 18