Antec AT100 Uživatelský manuál stáhnout pdf (Strana 10)

2.5

XTERNAL

5.25”

EVICE

NSTALLATION

There are three externally accessible 5.25” drive bays. To access these bays, you must first remove the front

bezel and drive bay cover:

1. Press on the three tabs pictured to the left to release the front bezel. The

bezel should swing outward, like a door.

2. Lay the bezel face down to access the drive bay covers.

3. Remove the drive bay cover as shown below by pressing on the tabs and

lifting the cover out of the bezel.

4. Slide your 5.25” device into the bay from the front of the case.

5. Secure the drive into position in the drive cage using the provided

screws.

6. Mount any other 5.25” devices accordingly.

7. Connect the appropriate power and data cables to your device(s).

2.6

NTERNAL

2.5”

EVICE

NSTALLATION

At the bottom of your case, there are mounting holes designed to support

one 2.5” SSD device.

1. Locate the plastic bag labeled “For 2.5 HDD” and remove the 4

silicone grommets.

2. Install the grommets into the four holes at the base of the case at

the bottom of the drive bay area as shown. You should install them

with the thick part of the grommets facing the inside of the case.

3. Lay the One Hundred on its side, and hold the drive in place on top

of the grommets.

4. Secure the device to the case with the screws provided, tightening

the screws with your fingers first, and then the screwdriver.

5. Connect the appropriate power and data cables to your

device

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Žádné komentáře

Antec AT100 Uživatelský manuál Strana 10